What are the Difference between Lug and Wafer Type Butterfly Valves?

What are the Difference between Lug and Wafer Type Butterfly Valves?

The Butterfly valves have often been used for many years as they are put into use in a number of functions. They appeared in the 1930s and were used by various industries. In many cases they are made of cast iron metal and the term depends on the functions of its own disc. There are also several varieties of kp-lok.com butterfly valves, but they are divided into two basic types, namely wafer butterfly valves and lug butterfly valves.

Butterfly valves are classified as quarter-turn valves. When a metal disk forming a part of the valve structure rotates a quarter of a twist, it opens and closes. The disc is called “butterfly” and attached to the pole. When the throttle is fully open, the disc spins (1/4 turn) allowing almost unlimited fluid flow. You may as well try opening the valve slowly to minimize the flow. Shut down the valve by turning the butterfly valve to prevent fluid from passing through. Indeed, the disc is always perpendicular or parallel to the flow and pressure irrespective of the positioning.

The Lug butterfly valve

The lug valve has a lug for attaching the valves to the lugs, the flange is attached to each end of the pipes and the length of each pipe can be removed and replaced independently. There are usually 8 or 12 lugs and 4 or 6 lugs are used to connect each pipe.

The lug model of the design butterfly valve is just like a three- part ball valve in which just one terminate of the hose can be released without affecting the opposite part. This could be done because each flange has a threaded insert with its own thread. The flange consists of a couple of pieces of lugs that do not use nuts. There is no have to shut down the over-all structure to repair, clean, inspect, or replace the lugs butterfly valves.

The Wafer butterfly valve

The function of the wafer butterfly valve is to maintain the cover to safeguard the bidirectional air pressure different in the fluid flow. This means that, the wafer model of the butterfly valve is designed to maintain a secure seal against bidirectional pressure differentials to prevent backflow in unidirectional flow systems. This is often achieved by utilizing precisely machined O-rings, seals,

hermetic seals and the use of flat valve faces in the downstream as well as upstream parts of the valves.

Wafer valves do not have attachment lugs but there is alignment lugs. They are tightened by two tubes between the flanges at both ends. To replace any length of pipe, the system must be shut down.

What are the Difference between Lug and Wafer Type Butterfly Valves?

Wafers valves and Lug butterfly valves are utilized in a variety of industrial applications such as pharmaceuticals, petroleum, food processing, chemicals, water and misuse waters administration. Valves used over these companies are typically manufactured in accordance with the Pharmaceutical quality / Manufacturing Standard, (Current good manufacturing practice) standard. Most butterfly valves replace the ball valve in many companies. This might be specifically true for people who use oil because it is cheap and even simple to set up. Pipelines with butterfly valves cannot be used for pigging cleaning. Pigging is the process of performing various maintenance tasks using equipment called “pig”.